Table of Contents
Advertisement
Installation And Removal
WARNING: Please read the following safety and anti-static
information before removing the module from its anti-static
packaging.
Safety Information
To avoid having dangerous equipment:
Installation of this module should be carried out by qualified
personnel only.
This module operates under SELV conditions (Safety Extra Low
Voltage) according to IEC 950, the conditions of which are
maintained only if the equipment to which it is connected is also
operational under SELV.
The LinkBuilder MSH chassis must be earthed.
Anti-Static Information
To avoid damaging the module:
Do not remove the module from its anti-static packaging until you
are ready to install it into the LinkBuilder MSH chassis.
Do not touch the pins, leads, connections or any components on
the module.
Handle the module only by its edges.
Always wear an anti-static wristband connected to a suitable
earth point.
Always store and transport the module in anti-static packaging.
Please refer to the How To Install And Use The LinkBuilder
MSH/11 manual for information on installing and removing the
bridge module.
DUA1860-0AAA01
Installation And Removal
1-31
Advertisement
Table of Contents
