Deleting Virtual Circuits; Managing The Video Dial Feature - 3Com SuperStack II PathBuilder S330 Reference Manual

Deleting Virtual Circuits

Managing the Video
Dial Feature
4 Follow the prompts that appear at the bottom of the screen to modify the circuit
parameters as desired.
To delete an existing virtual circuit:
1 From the Virtual Circuit menu, select [4] Delete Virtual Circuit. The Delete Virtual
Circuit screen appears. This screen displays a list of existing virtual circuits.
2 Enter the VC# of the circuit you want to delete.
The following prompt appears:
Are you sure you want to delete VC# <VC number>
where is the number of the selected virtual circuit.
<VC number>
3 Enter in response to the confirmation prompt to delete the circuit.
y
When you delete a virtual circuit involving the CBR module in structured voice
mode, the DS0 channels associated with that circuit are trunk conditioned and can
no longer be used. See "DS0 Trunk Conditioning" earlier in this chapter for further
details about trunk conditioning.
This section tells you how to manage video dial-up sessions and view the call
routing table.
Before you can establish video dial-up sessions, you must configure video virtual
circuits. For details see "Defining RS-366 (Video) Virtual Circuit Templates" earlier
in this chapter.
You manage the video dial feature from the Manage Video Dial menu, shown in
Figure 144.
To open the Manage Video Dial menu:
From the Configuration Management menu, select [5] Manage Video Dial.
Figure 144 Manage Video Dial Menu

Managing the Video Dial Feature

155