3Com SuperStack II PathBuilder S330 Reference Manual page 72

58 C 3: G S
HAPTER ETTING TARTED
Figure 54 Add Virtual Circuit Menu
3 Build a PVC on the far-end PathBuilder S330/S310 switch, using the MCPU as side
A of the circuit. Set the following parameters on the Add Virtual Circuit screen:
Shaper Number — Choose the number corresponding to the desired shaper
value. You assign the shaper number from the MCPU Shapers screen. See
"Configuring MCPU Shapers" in Chapter 4, for details.
IP Address — You must use a the same subnet as the one you used for the
near-end PathBuilder S330/S310 switch.
Subnet Mask — Specify a valid subnet mask for the IP address (for example,
255.255.255.0).
VPI/VCI — You must use the same values as you did for the near-end
PathBuilder S330/S310 switch.
IP Encapsulation — Specify the encapsulation type used for sending IP
packets over the ATM link. You must set the near and far ends to the same IP
Encapsulation type.
4 Open the Manage IP Network Configuration menu. (From the Configuration
Management menu, select [6] Manage IP Network Configuration).
5 On the Manage IP Network Configuration menu, select [3] Default Gateway
Configuration and set the following:
a Set the default gateway on the far-end PathBuilder S330/S310 switch to the
PVC IP address you set for the near-end PathBuilder S330/S310 switch in step
1.
b Set the default gateway on the management station to the local host IP
address of the near-end PathBuilder S330/S310 switch.
For details about setting the default gateway, see "Configuring the Default
Gateway" earlier in this chapter.