Correct The Settings For A Copy Job - Oce VarioPrint 2090 Function Manual

Correct the settings for a copy job

Introduction
You can define or change the settings of a copy job until you press the start key
or the set-build key
editor. There you select the required job settings. Use the correction key
correct the settings.
How to correct the quantity setting for a copy job
Press the correction key
1
prints).
Use the numeric keys to enter a new value.
2
Press the start key
3
If the number of prints is 1, you can not reset the quantity setting to
Note:
default. In this case, the job settings are set to default when you press the
correction key once.
How to correct the settings in the 4 copy job sections
Press the correction key
1
the job editor. This action changes all the copy job settings back to the default
value.
Use the function keys above the operator panel to access the 4 copy job
2
sections.
Use the function keys below the operator panel to select the required settings.
3
Press the start key
4
Copy jobs
. When you create a copy job, you open the job
once to reset the quantity setting (number of
to send the job to the job queue.
two times to reset the values in the 4 sections of
to send the job to the job queue.
to
77