Copy Special Originals And Originals Of A Non-Standard Size - Oce VarioPrint 2090 Function Manual

Copy special originals and originals of a non-standard size

Introduction
Special originals can cause problems in the automatic document feeder. Use
the glass plate to copy special originals.
Special originals are the following.
Pages from a bound original like a book or a magazine
■
Damaged or curled originals
■
Originals of a non-standard size.
■
When the original is put on the glass plate, the original sheet size and the
orientation of the sheet are not automatically detected. The Océ VarioPrint
2090 assumes that the original sheet size is the same as the default print sheet
size. The default sheet orientation is vertical. The system uses an automatic
zoom value for the print. The result is that the system assumes that the original
on the glass plate is a portrait original of a standard size, for example A4 (if A4
is the default print sheet size available in the paper tray).
To copy an original of a non-standard size and orientation, you must manually
set the sheet orientation to vertical (portrait) or horizontal (landscape).
Make sure that the original fits in the following ranges.
The minimum size for the short edge is 10 mm. The maximum size for the
■
short edge is 297 mm.
The minimum size for the long edge is 10 mm. The maximum size for the
■
long edge is 432 mm.
To copy an original of a certain (non-standard) size and orientation to a
different size, use the manual zoom setting to adjust the zoom factor. Use the
following information as a reference for standard conversions.
[14] Zoom factors
Original
A3
A4
A5
[14] Zoom factors
78 Océ VarioPrint 2090 Job manual
Print
A4
A3
A4
Zoom factor in %
71
141
141