Handle Errors On The Océ Varioprint 2090 - Oce VarioPrint 2090 Function Manual

Handle errors on the Océ VarioPrint 2090
Introduction
If an error occurs, the Océ VarioPrint 2090 stops to process.
There are three types of errors that can occur on the Océ VarioPrint 2090 .
ORE (operator recoverable error)
■
You must resolve the error locations before scanning or printing can
continue. After the error locations are resolved, the Océ VarioPrint 2090
will automatically continue with the active job unless the operator has to
perform an additional activity (e.g. reload originals). After this error the
system will still be stand-by.
MRE (machine recoverable error)
■
After this message the system goes to sleep mode. You only need to turn on
the system again. Follow the instructions on the screen.
PE(permanent error)
■
If the system has a permanent error, the Océ VarioPrint 2090 stops. An
error screen indicates that service is required. Only a service technician can
resolve the error and remove the message.
The scan process and the print process are separate processes. If one
Note:
process of the two processes has an error, the other process will continue.
The error screen
Screen messages or error screens A message shows you which areas you
must inspect to find the error. A picture shows you how to correct the error.
After you correct the error, the error screen disappears and the Océ VarioPrint
2090 starts to process.
The (ORE) error screen is divided into two sections, a left-hand section and a
right-hand section.
The right-hand section shows the part of the Océ VarioPrint 2090 where the
error occurred. The screen gives you instructions for the area that you must
inspect. If necessary, open doors or covers to access these areas.
The left-hand section shows all the actions to take. The Océ VarioPrint 2090
traces your actions and marks the steps on the screen. After you have checked
all the indicated areas and after you have corrected the problems, the error
screen disappears.
Error handling 101