Power Modes On The Océ Varioprint 2090 - Oce VarioPrint 2090 Function Manual

Power modes on the Océ VarioPrint 2090
Introduction
This section describes the power modes of theOcé VarioPrint 2090 .
OFF
The Océ VarioPrint 2090 is turned off completely, because the Océ Smart
Imager, that controls the power of the system is turned off. You can not reach
the system via the network. The operator panel if off as well as the LEDs next
to the operator panel.
Controller initialising
This state describes that the controller is booting, testing and starting up
applications. The system remains off.
The LEDs on the right-hand side of the operator panel are blinking green.
1
The screen becomes active after some time and shows that the system is
2
starting up.
The LED in the On/Off button
3
When the controller initialisation is ready, the message 'Press
4
the Océ VarioPrint 2090 ' appears. The LEDs on the right-hand side of the
operator panel turn off.
The LED in the On/Off button
5
When a PIN code protects the safety sleep mode and you press the On/Off
button
Stand-by mode
The initialisation of the controller is complete. The system is ready to print and
copy. the On/Off button
Safety sleep mode
When the system is in the safety sleep mode, the operator panel is off. The
system goes to the safety sleep mode in the following situations.
When you press the power switch
■
When the power returns after a mains failure.
■
Press the On/Off button
22 Océ VarioPrint 2090 Job manual
, you must enter the PIN code.
is green.
to get the system out of the safety sleep mode.
blinks (amber).
becomes amber.
.
to switch on