Remote Control - Dimplex MULTIFIRE DF3215 Parts & Service Manual

DF3215

REMOTE CONTROL

The remote control has a range of approximately 50 ft. (15.25m), it does not have to be
pointed at the fireplace and can pass through most obstacles (including walls). It is
supplied with 243 independent frequencies to prevent interference with other units.
BATTERY INSTALLATION
1. Depress tab on the battery cover on the back of the remote transmitter and
remove battery cover.
2. Install 3 AAA batteries into the remote control (included).
3. Replace the battery cover.
NOTE
The remote transmitter has a battery backup time of 24 hours. The batteries can be
removed for up to 24 hours before the transmitter will require re-initialization.
NOTE
When the Low Battery icon
replace the batteries promptly, to maintain full functionality of the remote/fireplace
(FIGURE 5).
INITIALIZING THE REMOTE CONTROL
1. Plug cord into 120 volt wall outlet.
2. Turn ON the electrical power at the circuit breaker.
3. Ensure the Main On/Off switch located inside the fireplace in the upper right hand
corner is in the
4. Set the 3 position manual control to Position 1 (left position).
5. Press and hold the initialization button on the unit.
6. While holding the initialization button, press the flame/heat ON/OFF
the Purifire™ ON/OFF
7. Release the initialization button on the unit. The remote control is now ready for
operation.
Batteries
is present on the remote control it is recommended to
ON position.
button on the remote control transmitter.
SERIAL No.
XXX XX
2
FIGURE 2
Initialization
Button
3 Position
Indicator
Manual
Light
Control
button or
Main
On/Off
Switch
FIGURE 3