Power Cord Replacement - Dimplex MULTIFIRE DF3215 Parts & Service Manual

DF3215
If unit was operating prior to servicing allow at least 10 minutes for light bulbs and
heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.
TO REPLACE POWER CORD
1. Remove firebox from mantel.
2. Remove (8) screws from top panel.
3. Locate and disconnect the power cord wiring from the main on/off switch and from
the remote control receiver noting their original locations.
4. With needle nose pliers grasp the power cord strain relief grommet from inside the
rear panel and push while twisting to remove.
5. Pull the power cord out through the hole in the rear cover.
6. Install the new cord set through the hole in the rear cover by placing the strain relief
over the cord, hold the strain relief with pliers and slide into mounting hole.
7. Connect all of the wiring connections in their original locations on the main on/off
switch and the remote control receiver.
8. Reassemble in the reverse order as above.
17