Dimplex DF3215 Quick Start Manual

Hide thumbs Also See for DF3215:

Download this manual

FEDERAL COMMUNICATIONS COMMISSION

INTERFERENCE STATEMENT

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following

measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

CAUTION:

Any changes or modifications not expressly approved by the grantee of this

device could void

the user's authority to operate the equipment.

Page 1 FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Page 2 Time of day Room temperature Set temperature Day of week Remote display Up button Enter button Left Button Right Flame ON/OFF button button Down button Batteries Sleep timer Heater ON/OFF button button Occupancy Ambient Light Sensor Sensor FLAME ON/OFF BUTTON Press the Flame On/Off button to turn the flame ON.
Page 3 5. Press the up button and the hour display will flash. 6. Use the left or right button to set the hour. 7. Press the up button and the minute display will flash. 8. Use the left or right button to set the minute. 9.
Page 4 NOTE To turn the ambient light sensor OFF repeat steps 1 to 3 and then press the down button. SLOW START/FADING EMBERS If the slow start function is being used at start up then the fading embers function will automatically be programmed at shut down. 1.