Restrictions - Nortel BCM50 Troubleshooting Manual

Table 14 Preferences details fields for lines (Sheet 3 of 3)
Attribute Value
Legend: Loop = analog/digital loop; GS = ground start; DID = DID; E&M = E&M; BRI = BRI; DPNSS
= DPNSS; VoIP = VoIP; TL = Target and DASS2. Note: PRI fields are all included under the main
panel.
Warning: Enable modules
If you disabled any trunk media bay modules prior to performing programming, enable them now to
ensure your system will function properly.

Restrictions

Assigning Line restrictions and Remote Access Package restrictions are part of the configuration
for controlling calls out of the system (line restrictions) and into the system from a private network
node or from a remote user calling in over the PSTN lines (Remote Access Packages).
The Restrictions tab shows the restrictions for a line.
Table 15 describes the fields on this panel.
Table 15 Restrictions
Attribute
Use remote package <remote package #>
Schedule
Line Restrictions -
Use Filter
Remote Restrictions
- Use Filter
Description
Values
Default: Normal, Night, Evening, Lunch, Sched 4, Sched 5, Sched 6
<00-99>
<00-99>
Chapter 4 Software Troubleshooting
Description
If the line is being used to receive external calls or calls
from other nodes on the private network, ensure that
you indicate a remote package that provides only the
availability that you want external callers to have. This
attribute is typically used for tandeming calls.
Enter the restriction filter number that applies to each
schedule.
(controls outgoing calls)
Enter the restriction filter that applies to each schedule.
This setting provides call controls for incoming calls over
a private network or from remote user dialing in over
PSTN)
BCM50 Troubleshooting Guide
45