Table of Contents
Advertisement
Configuring the Model 281xSA Hub for IP/IPX Networks
4-32
IP Parameters Menu
Current working parameters:
IP Address:
Subnet Mask:
Router IP Address:
Secondary Router IP Address:
Restart parameters (valid only if restarted) :
IP Address:
Subnet Mask:
Router IP Address:
-a
Set my IP address
-m
Set subnet mask
-r
Set default router's IP address
-d
Set secondary default router's IP address
-ESC
Return to Protocol Parameter Menu
Enter command:
Figure 4-18. Changing the IP parameters
Each time you change one of the run-time parameters on this menu, the screen
scrolls to show the new setting on the "Restart parameters" part of the menu.
This menu includes the following commands:
a
[Set my IP address] Up to 12 numeric characters, written in
dotted decimal notation (N.N.N.N, with N being a value from 0 to
255, inclusive). These characters identify the network address of
the Model 281xSA hub. To set this address to [none], enter 0.0.0.0.
If the address is none, that parameter entry remains blank at the top
of the menu.
m
[Set subnet mask] Up to 12 numeric characters, written in dotted
decimal notation. To set this address to [none], enter 0.0.0.0. See
"Subnetting" in Appendix F, "IP Addressing," for a description of
subnet addresses.
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
[none]
xxx.xxx.xxx.xxx
987.654.321.2
987.654.321.2
4769
893-743-A
Advertisement
Table of Contents
