Service Port Run-Time Messages - Bay Networks 281xSA Using Manual

System Messages

Service Port Run-time Messages

H-6
The messages listed in this section are associated with conditions that occur
while you are using the run-time configuration menus to change configuration
parameter values. You should see these messages only after the Model 281xSA
hub image code has loaded.
c-init: Can't read MAC address PROM
This error message indicates that the MAC address from the MAC address
PROM. It might occur if there is a problem with the MAC address PROM
hardware.
IPX node address has to be exactly 12 hexadecimal digits, hit <space> to
continue
You have entered an IPX trap receiver node address that is an incorrect length.
IPX node address has to be hexadecimal number, hit <space> to continue
You have entered an IPX node address that was not in the correct form.
It should contain only hexadecimal digits.
Segment number has to be exactly 8 hexadecimal digits, hit <space> to
continue.
You have entered an IPX segment number that is not a correct length.
Segment number has to be hexadecimal number, hit <space> to continue.
You have entered an IPX segment number that is not in the correct form.
It should contain only hexadecimal digits.
Warning: Can't write hardware configuration data to EEPROM.
The hub hardware configuration could not be written to NVRAM successfully.
This error might occur if there is a problem with the NVRAM hardware.
Warning: Hardware configuration in slot xx has changed since last restart.
This informational message indicates that the specified slot was reconfigured
since the last Model 281xSA hub image code restart.
Warning: Invalid or missing EEPROM. Use default value.
This error message indicates that values could not be read from NVRAM
893-743-A