Commands - Bay Networks 281xSA Using Manual

Configuring the Model 281xSA Hub for IP/IPX Networks

Commands

4-14
Boot Main Menu
MAC Address: 00:00:81:xx:xx:xx
Boot Mode:
Boot Protocol:
Management Protocol:
m -Toggle boot mode
p -Toggle boot protocol
t -Toggle management protocol
i -Toggle image load mode
f -Toggle config file load mode
k -Reset NVRAM to factory defaults
z -Reset management module
Figure 4-9. Sample configuration menu
Some commands switch between two or three possible settings; these
commands toggle a condition. Other commands allow you to enter information;
these commands set, add, or delete a parameter value. Specific commands on
the main menu shift the display to other menus from which you can select
additional commands.
To use the menus, follow these steps:
1. Press the key for the letter of the command you want to issue.
If you select a toggle command, the specified parameter changes its setting
in the upper part of the menu.
Network Image Load Mode: Remote w/local
Config Load Mode: Remote w/local
Auto
IP_IPX
c -System configuration menu
b -Boot file configuration menu
j -IP configuration menu
x -IPX configuration menu
e -Load and execute boot files
g -Perform power-up boot load sequence
w -Write boot config to NVRAM
281xSA Ethernet NMM
893-743-A
4756