Configuration File Messages - Bay Networks 281xSA Using Manual

Configuration File Messages
893-743-A
Writing configuration data to EEPROM . . . OK
Writing configuration data to EEPROM . . . Failed
These messages indicate whether or not the configuration data was successfully
written to NVRAM. The operation might fail if there is a problem with the
NVRAM hardware.
Writing values to EEPROM . . . OK
Writing values to EEPROM . . . Failed
These messages indicate whether or not the write-to-EEPROM request
succeeded. The request might fail if there is a problem with the NVRAM
hardware.
The messages in this section are associated with conditions that occur while
you are using the downloaded agent configuration file to change configuration
parameter values. You should see these messages only after the Model 281xSA
hub image code has loaded.
authentication-traps Unknown argument, xxxx, ignored.
An unknown parameter is specified for the authentication-traps keyword in the
configuration file. In this case, the system defaults to authentication-traps-on.
Bad data format in: xxxxx, ignored.
When this error message contains one of the following keywords in place of
xxxxx, the message indicates that no entry will be created in the allowed-nodes
table:
node
port
slot
conc
When this error message contains one of the following keywords in place of
xxxxx, the system uses the default value for the specified keyword:
allow-on
portlife

Configuration File Messages

H-7