Using Configuration Menus - Bay Networks 281xSA Using Manual

Configuring the Model 281xSA Hub for IP/IPX Networks
Using Configuration Menus
4-12
To configure the Model 281xSA hub through the service port, you use
configuration menus on the display of the terminal connected to the service
port. There are two series of configuration menus:
One menu series (see Figure 4-7) sets the primary boot configuration; that
is, it tells the hub how to identify itself to the network management
software. You can access this menu only before the image code is loaded.
To access this menu, press [Ctr]+C.
The other menu series (see Figure 4-8) modifies the run-time parameters;
use the menus to change operating parameters as the hub is running. You
can access these menus only after the image code is loaded. To access
these menus, press [Ctr]+Y.
Ctrl -
Toggle boot mode
Toggle boot protocol
Toggle management protocol
Toggle image load mode
Toggle config file load mode
Reset NVRAM to factory defaults
Reset management module
System configuration menu
Boot file configuration menu
IP configuration menu
IPX configuration menu
Load and execute boot files
Perform power-up bootload sequence
Write boot configuration to NVRAM
Figure 4-7. Primary boot configuration menus
C
Toggle all RAM tests
Return to Boot main menu
Set server's IP address
Set boot router's IP address
Set config file name
Set image file name
Get config file info from network
Return to Boot main menu
Set IP address
Set subnet mask
Set default gateway
Get IP information from network
Return to Boot main menu
Get Network Number via network
Set Network Number
Return to Boot main menu
893-743-A
4759