Configuring the Model 281xSA Hub for IP/IPX Networks
4-6
If the error clears, the diagnostics continue and the hub LEDs light as follows:
Power LED—on
On Line LED—flashing
NM Control—LED off
Fault LED—off
After completing its diagnostics, the Model 281xSA hub continues
automatically, trying to find the BootP server that has its configuration
parameters. Figure 4-3 shows an example of the service port screen during a
BootP sequence.
Model 281xSA Code Downloading Starting
Type [Ctrl] + C to go to Boot Main Menu
DCE#1 trying BOOTP
Figure 4-3. BootP service port screen display
To stop the automatic process and access the Model 281xSA boot configuration
menus, press [Ctrl]+C. See "Setting the Boot Configuration without a BootP
Server" later in this chapter.
4755
893-743-A