Bay Networks 281xSA Using Manual page 133

Setting Up the Model 281xSA Hub Configuration File
G-6
# Specify the action to be taken when a node security violation
# occurs. Actions can be specified for violations at the port, slot,
# or concentrator level.
# port slot# port# action#
# slot slot# action#
# conc action#
# Where slot#, port#, action# are all decimal numbers.
# For action#, valid choices are 2, 3, 4, or 5.
# 2 = no_action;
# 3 = send_trap_only;
# 4 = partition_port_only;
# 5 = send_trap_and_partition_port;
#
# This port-level example is used to check slot 5, port 11.
# If address violation occurs, send trap only.
#port 5 11 3
# This port-level example is used to check slot 4, port 12.
# If address violation occurs, do nothing.
#port 4 12 2
# This port-level example is used to check slot 2, port 3.
# If address violation occurs, send trap and partition port.
#port 2 3 5
#
# This slot-level example is used to check slot 5 and
# partition that port if address violation occurs.
#slot 5 4
# This slot-level example is used to check slot 3 and
# send trap and partition that port if address violation occurs.
#slot 3 5
#
# This concentrator-level example is used to check
# entire concentrator.
# send a trap and partition the port to which the concentrator
# is connected.
#conc 5
#
# Lock/Unlock security configuration. Valid entries are on and off.
# Default is off.
# For example:
#security-config-lock off
#
# Add an entry to the threshold table.
# Format of the command:
# threshold IN OB SL PO TY CN SV AC DU
# IN = index, for 281xSA from 1 to 160, inclusive
Formats are
If address violation occurs,
893-743-A