Task 7: Rac Configuration - Bay Networks 5399 Quick Start Manual

The Model 8000 console terminal is configured as follows:
• 9600 baud
• 8 data bits
• No parity
• 1 stop bit
• XON/XOFF flow control
Detailed installation instructions are in the Model 5399 Remote Access
Concentrator Hardware Installation Guide and Installing the Model 8000
Remote Access Concentrator.
Task 7: RAC Configuration
To configure the RAC, it must be in ROM monitor mode. The Model
5399 is accessible through the slot selection menu on the System 5000
MSX console. Press the Reset button on the Model 8000. When all the
lights flash, press the Reset button again.
A few minutes may pass before the ROM monitor (monitor::)
prompt appears.
Once the RAC is in ROM monitor mode, perform the following tasks:
• Set the network address
• Set the operating image
• Configure the interface sequence
• Enable the allow_snmp_sets parameter
Quick-Start Guide for Remote Access Concentrators
118352-A Rev. A
5