Front bezel security
The front bezel can be locked in place by installing a security screw provided by HP. To install the
security screw:
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove one of the five silver 6-32 standard screws located on top of the drive cage.
4.
Install the security screw through the middle front bezel release tab to secure the front bezel in
place.
5.
Replace the access panel.
6.
If the computer was on a stand, replace the stand.
68
Chapter 6 Removal and replacement procedures – small form factor (SFF) chassis
(Preparation for disassembly on page
(Access panel on page
67).
66).