HP EliteDesk 705 G1 Microtower Maintenance And Service Manual page 171

Control panel message
1155-Serial Port Address Conflict Detected
1720-SMART Hard Drive Detects Imminent
Failure
1796-SATA Cabling Error
2212-USB Key Provisioning failure writing to
device
2217-ME Firmware Version request failure
2218-ME Firmware Version should be
updated
2219-USB Key Provisioning file has invalid
header identifier
Description
Both external and internal serial ports are
assigned to same IRQ.
Hard drive is about to fail. (Some hard
drives have a hard drive firmware patch that
will fix an erroneous error message.)
One or more SATA devices are improperly
attached. For optimal performance, the
SATA 0 and SATA 1 connectors must be
used before SATA 2 and SATA 3.
USB device used for USB key provisioning
will not allow BIOS to update provision file
properly.
ME firmware is not properly responding to
BIOS query for version information.
ME firmware must be updated to match
current functionality contained in the system
BIOS.
Provisioning file contained on the USB key
has been corrupted or is not a valid version
for the current ME firmware.
Recommended action
3. Reconfigure card resources and/or run
Computer Setup or Windows utilities.
1. Remove any serial port expansion
cards.
2. Clear CMOS. (See Appendix B,
Password security and resetting
CMOS on page
3. Reconfigure card resources and/or run
Computer Setup or Windows utilities.
1. Determine if hard drive is giving correct
error message. Run the Drive
Protection System test under using F2
Diagnostics when booting the
computer.
2. Apply hard drive firmware patch
if applicable. (Available at
http://www.hp.com/support.)
3. Back up contents and replace hard
drive.
Ensure SATA connectors are used in
ascending order. For one device, use SATA
0. For two devices, use SATA 0 and SATA
1. For three devices, use SATA 0, SATA 1,
and SATA 2.
1. Try a different USB key device for
provisioning.
2. If the error persists, update to the latest
BIOS version and ME firmware
version.
3. If the error still persists, replace the
system board.
1. Reboot the computer.
2. If the error persists, update to the latest
BIOS version and ME firmware
version.
3. If the error still persists, replace the
system board.
1. Update to the latest ME firmware
version.
2. If the error persists and system BIOS
has been recently updated, restore
previous system BIOS version.
3. If the error still persists, replace the
system board.
1. Recreate the provisioning file using
third party management console
software.
2. If the error persists and system BIOS
has been recently updated, restore
POST numeric codes and text messages 161
166.)