Drive Positions; Removing A Slim Optical Drive - HP EliteDesk 705 G1 Microtower Maintenance And Service Manual

Drive positions

1 Slim optical drive bay
2 3.5-inch secondary hard drive bay
3 3.5-inch primary hard drive bay
NOTE: The drive configuration on your computer may be different than the drive configuration shown above.
To verify the type and size of the storage devices installed in the computer, run Computer Setup.

Removing a slim optical drive

1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. Disconnect the power cable and data cable from the back of the optical drive.
CAUTION:
avoid damaging the cable.
(Access panel on page
(Front bezel on page
When removing the cables, pull the tab or connector instead of the cable itself to
(Preparation for disassembly on page
33)
34)
32)
Drives 45