Front Bezel Security; Drive Cage; Prepare The Computer For Disassembly (Preparation For Disassembly - HP 280 G4 MT Maintenance And Service Manual
Hide thumbs
Also See for 280 G4 MT:
- Maintenance and service manual (111 pages) ,
- Disassembly instructions manual (7 pages) ,
- Product end-of-life disassembly instructions (7 pages)
Table of Contents
Advertisement
Front bezel security
The front bezel can be secured in place by installing a screw through the front of the chassis into the front bezel.
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Install a 6-32 screw through the front of the chassis and into the screw hole located below the center bezel
release tab.
4.
Replace the computer access panel.
5.
Reconnect the power cord and any external devices, and then turn on the computer.
6.
Lock any security devices that were disengaged when the access panel was removed.
Drive cage
The drive cage must be fully removed to service internal components. To remove the drive cage:
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Remove the slim optical drive
5.
Disconnect the power cable and SATA cable (1).
(Preparation for disassembly on page
(Access panel on page
17).
(Preparation for disassembly on page
(Access panel on page
17).
(Front bezel on page
18).
(Removing a slim optical drive on page
16).
16).
29).
Front bezel security
19
Advertisement
Table of Contents
