Table of Contents
Advertisement
Front bezel security
The front bezel can be secured in place by installing a screw through the front of the chassis into the front bezel.
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Install a 6-32 screw through the front of the chassis and into the screw hole located below the center bezel
release tab.
4.
Replace the computer access panel.
5.
Reconnect the power cord and any external devices, and then turn on the computer.
6.
Lock any security devices that were disengaged when the access panel was removed.
Drive cage
The drive cage must be fully removed to service internal components. To remove the drive cage:
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Remove the slim optical drive
5.
Disconnect the power cable and SATA cable.
18
Chapter 4 Removal and replacement procedures
(Preparation for disassembly on page
(Access panel on page
16).
(Preparation for disassembly on page
(Access panel on page
16).
(Front bezel on page
17).
(Removing a slim optical drive on page
15).
15).
28).
Advertisement
Table of Contents
