HP EliteDesk 705 G1 Microtower Maintenance And Service Manual page 52

8. To install a new expansion card, hold the card just above the expansion socket on the system
board then move the card toward the rear of the chassis (1) so that the bottom of the bracket on
the card slides into the small slot on the chassis. Press the card straight down into the expansion
socket on the system board (2).
NOTE:
seats properly in the expansion card slot.
9. Rotate the slot cover retention latch back in place to secure the expansion card.
10. Connect external cables to the installed card, if needed. Connect internal cables to the system
board, if needed.
11. Replace the computer access panel.
12. Reconnect the power cord and turn on the computer.
13. Lock any security devices that were disengaged when the computer access panel was removed.
14. Reconfigure the computer, if necessary.
42 Chapter 5 Removal and replacement procedures – Microtower (MT) chassis
When installing an expansion card, press firmly on the card so that the whole connector