TEC MA-1650-4 Series Programming Manual page 72

* This address is applicable for V1.9 or after.
ADDRESS No.
40 EBT OPTION I
BIT ITEM
No.
[DISPLAY 1] Key Function
1
[DISPLAY 2] Key Function
2
[DISPLAY 3] Key Function
3
[DISPLAY 4] Key Function
4
[DISPLAY 5] Key Function
5
-- vacant --
6
-- vacant --
7
-- vacant --
8
NOTE 1: If SET status is selected, the operation of the [DISPLAY] key performed after tendering operation will
be prohibited.
Each bit status selection is effective only when "RESET" status has been selected for the corresponding
bit of the next address (Address 41).
If both this address and the next address are SET or RESET, the operation of total/over-tendering/short-
tendering will be allowed using each [DISPLAY] key.
SYSTEM OPTION TABLE
CONTENTS
SELECTIVE STATUS
TENDER/TOTAL
RESET
SET TOTAL ONLY
RESET TENDER/TOTAL
TOTAL ONLY
SET
RESET TENDER/TOTAL
SET TOTAL ONLY
TENDER/TOTAL
RESET
SET TOTAL ONLY
RESET TENDER/TOTAL
TOTAL ONLY
SET
RESET
SET
RESET
SET
RESET
SET
- 69 -
Standard Bit Set (auto-set by RAM Clear)
REMARKS
STANDARD
STATUS
NOTE 1 below
*
*
*
*
*
*
*
*
EO3-11070
MA-1650-4 SERIES
0