TEC MA-1650-4 Series Programming Manual page 131

• On V1.9 or after, the names shown on the table below are initially programmed for credit card company names.
Company
ID Code
1
2
3
4
5
6
7
8
9
10
11
19
ENDORSEMENT MESSAGE PROGRAMMING (Submode 22)
The message programmed here will be printed on the check as endorsement message by the Remote Slip Printer
(hardware option) or by the Receipt/Journal Printer with the multi-validation function. The print will be activated
by depressing the [CHECK No.] key after finalizing the sale.
CONDITION
OPERATION
24 [X]
NOTES: 1. When all the three lines are programmed with all blanks, no empty line feeding will occur in actual
printing on the remote slip printer. But when only one line is programmed with any character and
the other two lines are programmed with all blanks, two empty line feeding will occur.
On the receipt/journal printer, lines comprised of spaces are not fed. (When one line is
programmed, the remaining two lines are not fed in actual printing.)
2. A maximum of 30 characters may be entered for each line. When a double-sized character is
entered, it occupies two regular-sized characters' space.
3. If a double-sized character is entered at the 24th digit in the Character Entries sequence, its
regular-sized character is printed at the 25th digit (i.e. 1st digit on the next line) in the programming
receipt (due to Receipt/Journal printer's capacity in programming operations).
4. When a value is entered for "Line Feed Value," printing of data actually starts after feeding the
number of lines of the entered value. The value may range from 0 to 16 for Remote Slip Printer,
or from 0 to 11 for Receipt/Journal Printer.
Initial Program
V|I|S|A| | | | | | | |
M|A|S|T|E|R| |C|A|R|D|
A|M|E|X| | | | | | | |
D|I|S|C|O|V|E|R| | | |
D|I|N|E|R|S|S|C|L|U|B|
J|C|B| | | | | | | | |
C|R|T|0|7| | | | | | |
C|R|T|0|8| | | | | | |
C|R|T|0|9| | | | | | |
C|R|T|1|0| | | | | | |
C|R|T|1|1| | | | | | |
A|U|T|H|H|P|R|O|C|E|S|S Used for the EBT feature
Any time outside a sale
Mode Lock: SET
|Line No.| [ST]
1 to 3
*
Repeat for other lines.
Character Entries [ST]
- 128 -
Remarks
|Line Feed Value|
0 to 16 (See NOTES 4, 5.)
* (For sequentially programming
lines, the Line No. specification
can be skipped.)
EO3-11070
MA-1650-4 SERIES
[AT/TL]