Atx Power - SOYO SY-KT400 Dragon Ultra User Manual

Hardware Installation
F. ATX Power Supply
Plug the connector from the power directly into the 20-pin male ATX PW
connector on the motherboard, as shown in the following figure.
Warning: Follow these precautions to preserve your motherboard
from any remnant currents when connecting to ATX power supply:
Turn off the power supply and unplug the power cord of the ATX
power supply before connecting to ATX PW connector.
The KT400 DRAGON Ultra requires a power supply that is approved by AMD.
Go to www.amd.com
ATX power supply can take at least 720 mA * load on the 5V Standby lead
(5VSB) to meet the standard ATX specification.
* Note: If you use the Wake-On-LAN (WOL`) function, make sure the ATX
power supply can support at least 720 mA on the 5V Standby lead (5VSB).
□
for more info on approved power supply. Make sure the
35
SY-KT400 DRAGON Ultra

ATX Power

P2