SOYO SY-KT400 Dragon Ultra User Manual page 29

Hardware Installation SY-KT400 DRAGON Ultra
2. Reset
Plug the Reset push-button cable into the 2-pin Reset header on the motherboard.
Pushing the Reset button on the front panel will cause the system to restart the
boot-up sequence.
Reset Pin Assignment
1
Power Good GND
3. Speaker
Attach the 4-pin PC speaker cable from the case to the Speaker header on the
motherboard.
Speaker Pin Assignment
VCC NC NC Speaker out
4. IDE LED
Attach the 2-pin IDE device LED cable to the corresponding IDE LED header
on the motherboard. This will cause the LED to light up when an IDE (HDD,
CD-ROM) device is active.
HDD LED Pin Assignment
_
+
LED Anode LED Cathode
24