SOYO SY-KT400 Dragon Ultra User Manual page 35

Hardware Installation SY-KT400 DRAGON Ultra
3. Cooling Fan Installation
(1) CPU Cooling Fan (CPUFAN1,CPUFAN2)
After you have seated the CPU properly on the processor, attach the 3-pin fan
cable to the CPUFAN connector on the motherboard. The fan will stop when the
system enters into Suspend Mode. (Suspend mode can be enabled from the
BIOS Setup Utility, [POWER MANAGEMENT] menu.)
To avoid any damage to the system, install according to the following pin
assignment:
CPU Cooling Fan
(CPUFAN1,CPUFAN2)
CPUFAN Pin Assignment
CPUFAN1
1 2 3
GND 12V SENSOR
CPUFAN2
1 2 3
GND 12V NC
30