Ap-Detection - Motorola RFS7000 Series Reference Manual

20-8 Overview

20.1.5 ap-detection

Wireless Configuration Commands
Use this command to configure access port detection.
Syntax
ap-detection
[approved|enable|mu-assisted-scan|timeout (approved|unapproved)]
ap-detection approved add <1-200> (MAC Address)(SSID)
ap-detection mu-assisted-scan(enable|refresh<30-86400>)
Parameters
approved
enable
mu-assisted-scan
timeout <1-65535>
Example
RFS7000(config-wireless)#ap-detection enable
RFS7000(config-wireless)#
RFS7000(config-wireless)#ap-detection approved add 150 any any
RFS7000(config-wireless)#
RFS7000(config-wireless)#ap-detection mu-assisted-scan enable
RFS7000(config-wireless)#
RFS7000(config-wireless)#ap-detection mu-assisted-scan refresh 520
RFS7000(config-wireless)#
RFS7000(config-wireless)#ap-detection timeout approved 500
RFS7000(config-wireless)#
The approved access port list.
• add <1-200> – Adds an entry to the approved access port list.
• MAC Address – Select either:
• MAC– MAC address in AA-BB-CC-DD-EE-FF format.
• any– Any MAC address.
• SSID – Select either:
• LINE–A string of up to 32 characters.
• any– Any SSID.
Allows access ports to look for access points.
Mobile unit assisted scanning.
• enable – Enables mobile unit assisted scanning.
• refresh<30-86400> – The period (in seconds) used by all scan-capable
mobile units are polled to scan for neighboring access port's.
The interval (in seconds) an access port remains in the list after it is no longer
seen. Select one of the following options for timeout implementation.
• approved
• unapproved