Motorola RFS7000 Series Reference Manual page 227

route
routing
ssh
telnet
Usage Guidelines 1
By using the
ip access-list
• ext-nacl — Extended ACL. For more details see
• std-nacl — Standard ACL. For more details see
• dhcp – DHCP Server instance. For more details see
• dhcpclass – DHCP User Class instance. For more details see
• Use clear command to clear the ip dhcp binding.
NOTE To delete Standard/Extended and MAC ACL use
name>
Network Address Translation (NAT) allows a single device to act as a gateway for internal LAN clients. It
translates the clients internal network IP adresses into the IP address of the NAT enabled device.
RFS7000 supports port NAT and static NAT.
• Static NAT allows host on a private network and is accessible through internet using public IP's.
• Static NAT assigns a public IP to a host on a private network. It allows a host on a public network to
communicate with the host on the private network, using its public IP.
• Port NAT maps multiple local addresses to a single global address and dynamic port numbers.
Use to mark VLAN interfaces as an inside interface. The keyword
ip nat inside
interface as internal interface. This command is used in the
more detials.
Establish static routes.
• A.B.C.D – IP destination prefix. Adds a static route entry in the IP routing
table.
• A.B.C.D/M – IP destination prefix. Adds a static route entry in the IP
routing table.
• next hop – IP address of the next hop that is used in to reach the
destination.
Turn on IP routing.
Secured Shell (SSH) Server.
• port– Listening port. The value can be between 0-65536.
• rsa – RSA encryption key.
• keypair-name – Configures a RSA keypair used for encryption.
• WORD – RSA keypair name.
Telnet server.
• port – Value of the listening port. The value can be between 0-65535.
parameter you enter the following contexts:
Extended ACL Instance on page 14-1.
Standard ACL Instance on page 15-1.
under the Global Config mode.
DHCP Instance on page 17-1.
DHCP Class Instance on page 18-1
no access-list <access-list
inside
mode, check
(config-if)
5-31
defines the VLAN
ip on page 12-9 for