Tunnel - Motorola RFS7000 Series Reference Manual

12.1.20 tunnel

Interface Config commands
Use this command to configure protocol-over-protocol tunneling.
Syntax
tunnel(destination|source|ttl)
tunnel destination A.B.C.D
tunnel source A.B.C.D
tunnel ttl<1-255>
Parameters
destination
source
ttl
Example
RFS7000(config)#interface tunnel 1
RFS7000(config-if)#tunnel destination 172.168.200.20
RFS7000(config-if)#tunnel ttl 33
RFS7000(config)#show interfaces tunnel 1
Interface tunnel1
Hardware Type Tunnel, Interface Mode Layer 3
index=13, metric=1, mtu=1476, (PAL-IF)
Tunnel source 172.168.100.20, destination 172.168.200.20
Tunnel protocol/transport GRE/IP,
input packets 0, bytes 0, dropped 0, multicast packets 0
input errors 0, length 0, overrun 0, CRC 0, frame 0, fifo 0, missed 0
output packets 0, bytes 0, dropped 0
output errors 0, aborted 0, carrier 0, fifo 0, heartbeat 0, window 0
collisions 0
RFS7000(config)#
Destination of tunnel packets.
• A.B.C.D – Internet Protocol (IP).
Source of tunnel packets.
• A.B.C.D – Internet Protocol (IP).
Sets the time to live interval.
• <1-255> – The time to live (ttl) in seconds.
Tunnel TTL 33
<UP,POINTOPOINT,RUNNING,NOARP>
12-27