Road Display - Mercedes-Benz SL Operator's Manual

Navigation
346
Arrival time/distance to destination display
Symbol for destination
:
Distance to destination
;
Symbol for estimated time of arrival
=
Estimated time of arrival
?
You can only see this display during route
guidance.
While moving the map, you will see additional
data, depending on the crosshair position, if
the digital map supports this data. This might
be a street name, for example (
During route calculation, or if the vehicle is
traveling on a non-digitized road, the linear
distance to the destination is shown. In this
case, the display will be grayed out.

Road display

Road names or numbers, e.g. for
:
highways
Geo-coordinate display
Current height above average sea level
:
(rounded to the nearest 10 m)
Current vehicle position: latitude
;
coordinates
Current vehicle position: longitude
=
coordinates
Number of GPS satellites currently being
?
used
There must be sufficient GPS reception for all
displays to be shown. If this is not the case,
the display will be grayed out. Height
display : may vary from the actual value,
because the navigation system uses the GPS
signals for the calculation.
During the "Move map" function
( Y page 306), you will see the geo-
coordinates of the crosshair position. Height
display : and number of satellites used ?
are not displayed.
Y page 343).
Display switched off
Current map orientation
:
While moving the map, you will see additional
data, e.g. road names, depending on the
crosshair position, if the digital map supports
this data (
Coordinates on the map
X
To show the menu: press W the COMAND
controller.
X
Select
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
X
Select
confirm.
The map settings menu appears.
X
Select
confirm.
A menu appears.
Y page 343).
Navi
in the main function bar by
Map Settings
and press W to
Compass On Map
and press W to