Entering A Destination By Address - Mercedes-Benz SL Operator's Manual

Navigation
298
Carpool lanes may only be used under certain
conditions. Normally you can use these lanes
when two or more occupants are traveling in
the vehicle. However, there are lanes that can
only be used when three or four occupants
(e.g. in New York) travel in the vehicle. In
California, lone drivers can use a carpool lane
if their vehicle's emission level or fuel
consumption is below a fixed threshold.
Carpool lanes may be reserved for specific
times (e.g. during the peak period).
Carpool lanes are identified by HOV symbols
on special road signs and by markings on the
road. The road signs may also include the
designation CARPOOL. The lanes are arranged
as a separate lane next to the others or are
built as a physically separate lane.
Depending on the setting under
Occupants in
carpool lanes when calculating the route.
COMAND then guides you in and out of
carpool lanes using visual and acoustic
driving directions.
X
In the route settings menu, select
of Occupants in Vehicle
cVd the COMAND controller.
Number of
Vehicle, COMAND uses
Number
by turning
X
Select 1, 2 More than 2
or
cVd and press W to confirm.
A # dot indicates the current setting.
Destination input
Important safety notes
G
WARNING
For safety reasons, only enter a new
destination when the vehicle is stationary.
You could otherwise be distracted from the
traffic conditions, cause an accident and
injure yourself and others.

Entering a destination by address

Introduction
When entering an address as the destination,
you have the following options:
entering the state/province, city/ZIP code
R
and street
entering the state/province, city and
R
center
entering the state/province, city/ZIP code,
R
street and house number
entering the state/province, city/ZIP code,
R
street and intersection
entering the state/province, street, city
R
and house number
entering the state/province, street and
R
house number
entering the state/province, street and
R
intersection
by turning