Road Display - Mercedes-Benz 2013 SL Operator's Manual

Navigation
366
You can only see this display during route
guidance.
While moving the map, you will see additional
data, depending on the crosshair position, if
the digital map supports this data. This might
be a street name, for example.
During route calculation, or if the vehicle is
traveling on a non-digitized road, the linear
distance to the destination is shown. In this
case, the display will be grayed out.

Road display

Road names or numbers, e.g. for
:
highways
Geo-coordinate display
Current height above average sea level
:
(rounded to the nearest 10 m)
Current vehicle position: latitude
;
coordinates
Current vehicle position: longitude
=
coordinates
Number of GPS satellites currently being
?
used
There must be sufficient GPS reception for all
displays to be shown. If this is not the case,
the display will be grayed out. Height
display : may vary from the actual value,
because the navigation system uses the GPS
signals for the calculation.
During the "Move map" function, you will see
the geo-coordinates of the crosshair position.
Height display : and number of satellites
used ? are not displayed.
Display switched off
Current map orientation
:
While moving the map, you will see additional
data, e.g. road names, depending on the
crosshair position, if the digital map supports
this data ( page 362).
Y
Coordinates on the map
To show the menu: press W the COMAND
X
controller.
Select Navi in the main function bar by
X
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
Select Map Settings
X
confirm.
The map settings menu appears.
Select Compass On Map
X
confirm.
A menu appears.
Select Never, When Off-Road
X
Route Guidance Inactive
to confirm.
The selected setting is accepted.
Switching additional information on/off
Switching the topographic map on/off
To show the menu: press W the COMAND
X
controller.
Select Navi in the main function bar by
X
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
Select Map Settings
X
confirm.
The map settings menu appears.
and press W to
and press W to
or When
and press W
and press W to