Troubleshooting; The Machine Will Not Start; Overheating Cut-Out; Drying Takes Too Long - Asko DC7573 Operating Instructions Manual

Troubleshooting

The machine will not start

Check
• that the door is closed correctly.
• that the main power switch is on.
• that the machine is not programmed to start at
a specific time (e.g. 13.30)
• that the plug is connected.
• that the fuses (circuit breakers) in your house
are intact. Swap two circuit breakers over to
make sure. You cannot always tell from the
outside if a circuit breaker is broken.
• that the overheating cut-out has not been
triggered (see below).

Overheating cut-out

The overheating cut-out shuts off the dryer cabinet
if the temperature is too high.
• The overheating cut-out will reset automatically
once the machine has cooled down.

Drying takes too long

• Poorly spun or very wet washing.
• The dryer cabinet is positioned in an area
where the ambient temperature is too low.
The garments do not dry, or are too
dry
• The door has been opened while the program
is running, which disrupts the moisture
monitoring function.
• The garments may not have been hung
correctly, obstructing the air flow. See
"Garment placement" in the "Operation"
chapter.
• Wrong program selected, choose another
program, see the chapter "Operation".
• Poorly spun wash or very wet washing.
• The ventilation pipe/hose is too long. The
length should not exceed 1 m.
• Normal operation requires installation in a room
with a temperature above 0 °C.

Error messages

If F2 flashes on the display, the maximum
permitted program time has been reached. Read
"Drying takes too long" in the "Troubleshooting"
chapter to find out what to do.
21