4.16 USB board
4.16 USB board
Removing the USB board
To remove the USB board, follow the steps below and refer to Figure 4-25.
1. Remove the following screw and lift up the USB board to the left above.
• M2.5×6S Tapping screw
2. Disconnect the USB cable from the connector CN4622 on the USB board.
3. Disconnect the USB cable from the connector CN4610 on the system board and take
it out.
TECRA S3 Maintenance Manual (960-532)
CN4610
Figure 4-25 Removing the USB board
×1
M2.5×6S Tapping
USB cable
[CONFIDENTIAL]
4 Replacement Procedures
USB board
CN4622
4-39