Sr Board/Dc-In Jack; Removing The Sr Board/Dc-In Jack; Figure - Toshiba TECRA S4 Maintenance Manual

Personal computer

Hide thumbs Also See for TECRA S4:

Table of Contents

4.18 SR board/DC-IN jack

To remove the SR board/DC-IN jack, follow the steps below and refer to Figure 4-27.

1. Remove the following screw and take out the SR board from the slot.

• M2.5×6S Tapping screw

2. Disconnect the SR/USB cable from the connector CN9510 on the SR board.

3. Remove the following screw and serial harness holder.

• M2.5×6S Tapping screw

4. Disconnect the SR/USB cable from the connectors CN3421 and CN4611 on the

system board.

5. Take out the DC-IN jack from the slot and disconnect the DC-IN jack cable from

the connector CN8800 on the system board.

M2.5×6S Tapping

TECRA S3 Maintenance Manual (960-532)

Figure 4-27 Removing the SR board/DC-IN jack

4 Replacement Procedures

M2.5×6S Tapping

Serial harness holder

[CONFIDENTIAL]

Table of Contents