4.17 Internal microphone
4.17 Internal microphone
Removing the Internal microphone
To remove the internal microphone, follow the steps below and refer to Figure 4-26.
1. Remove the following screws and front panel.
• M2.5×6S Tapping screw
2. Disconnect the microphone cable from the connector CN6050 on the system board.
3. Take out the internal microphone from the slot of the front panel.
M2.5×6S Tapping
TECRA S3 Maintenance Manual (960-532)
Figure4-26 Removing the internal microphone
×2
[CONFIDENTIAL]
4 Replacement Procedures
M2.5×6S Tapping
Microphone
Front panel
Microphone cable
CN6050
4-41