4 Replacement Procedures
Installing the Switch membrane
To install the switch membrane, follow the steps below and refer to Figure 4-17.
1. Install the switch membrane in place and secure it with the following screw.
•
2. Connect the switch cable to the connector CN3260 on the system board.
3. Slide the switch cover to the below to install and secure it with the following screw.
•
4-30
M2.5×4B FLAT HEAD screw
M2.5×4B FLAT HEAD screw
[CONFIDENTIAL]
4.12 Switch membrane
x1
x1
TECRA S3 Maintenance Manual (960-532)