Rear Wheel - Invacare Mirage Service Manual

8

Rear Wheel

Parts
1 Tyre
2 Inner Tube
3 Inner Rim
Outer rim
4 Screws
5 Washer
6 Wheel Bolts
7 Motor shaft Bolt
8 Wheel Hub
9 Key
8.1 Tools Required:
1. 5mm Hex Wrench
2. Mallet
3. Pressure Gauge
4. Pump
5. Vice
6. Valve Remover
7. Flat Bladed Screwdriver
8. Torque Wrench
8.2 Inspection
1. Check wheel is not buckled or physically damaged. Replace if required.
2. Check tyres for wear and correct inflation, both wheels should allow the same degree of wear
(see side of tyre for pressure rating).
8.3 Disassembly
Caution:
• Take care while supporting the wheelchair in order to remove the wheel.
•
The Batteries should be removed before continuing with this procedure.
1. Jack up one of the gearboxes to lift one wheel off the floor.
2. Remove the four Wheel Bolts (6) securing the Wheel to the Wheel Hub (8) using a 5mm Hex
Wrench. Remove the Wheel.
3. Deflate the tyre (1), locate, loosen and remove Socket Head Cap Screws (4) securing the two
halves of the Wheel Rims (3) together using a 5mm Hex Wrench.
14
2
5
7
6
1
8
4 3
9