•
No 2 Cross Point Screwdriver
•
5mm Hex Wrench
•
10mm open ended spanner
•
Mallet
5.2
Inspection:
1. Check that the footplate fits securely and operates correctly.
2. Check the operation of the footplate extension, clamping and adjustment screw (5).
3. Check the legrest for damage.
4. Check the hanger lock for damage or excessive wear (7).
5.3
Disassembly / Assembly
1. Operate the legrest release mechanism and remove from the wheelchair.
2. Release the height adjustment screw (5) and slide the lower footplate tube from the hanger.
Use a mallet to gently tap the footplate if the tube will not move.
Hanger
1. Remove screws (5) and (6) using a 5mm Hex Wrench.
2. Slide Hanger support assembly (2) over the end of the hanger tube (1). Gently tap with a mallet
if it will not move.
3. Remove screw (4) with a No 2 Cross Point screwdriver and slide out hanger pivot (5)
Note:
It is NOT possible to disassemble the Hanger support (2).
Footplates (Standard and Adjustable)
1. Remove screw (11) using a 5mm Hex Wrench.
2. Separate the footplate (10) from the lower legrest tube (9).
3. Take care not to damage the spacers (12) or adjustment fixings (13) if fitted.
Hanger Locks
1. Remove fixing screw and nut (8) using a 10mm spanner.
2. Remove Hanger (7) Lock from wheel chair.
To re-assemble reverse the above steps taking care not to over tighten the fixing screws.
10