Invacare Mirage Service Manual page 24

Joystick Remote
1. Unplug the shark remote (1) from shark power module (4).
2. Depending on the type of control arm (3) fitted to the wheelchair, remove the screws (2) using
either a 5mm Hex Wrench or 8mm Open Ended Spanner. Remove Joystick Remote
3. Remove the Joystick Knob (8) by firmly pulling upwards (if required).
Power Module
1. Unplug the remaining connectors from the power Module.
2. Remove screws (7) using a 3mm Hex Wrench and a 7mm Open Ended Spanner in one
position. The Power Module is now free.
3. To remove the power module bracket (5) from the wheelchair seat stays (see section 9)
remove screw (6) using a 5mm Hex Wrench 10mm open ended spanner.
12.4 Assembly
1. To re-assemble reverse the above steps, ensuring that all fixing holes are aligned. Take care not
to over tighten the fixing screws.
Note:
•
When fitting the joystick remote screws (2) be sure not to use a torque in excess of 2 NM.
12.5 Power Module Connector Orientation
A
1
B
C D
Position :
E
A
B
C
D
E
All connectors are polarized and may
only be fitted in one possible position
Part :
1
Motor Cable (LH Motor)
Battery Cable
Motor Cable (RH Motor)
NOT USED
Shark Joystick Remote
Cable.
Battery wire Harness.
23