Safety And Assembly Instructions - Invacare Mirage Service Manual

2

Safety and assembly instructions

These safety instructions are intended to prevent accidents at work and it is imperative that they are
observed.
2.1 Before any inspection or repair work
Read and observe this repair manual and the associated operating manual.
Caution:
• Please note the heavy weight of some components. This applies especially to the removal of
drive units and batteries.
• The wheelchair must be switched off before removal of voltage-carrying components.
•
To do this, disconnect the batteries or remove them.
• When making measurements on voltage-carrying components, avoid short-circuiting the
contacts.
• Danger of fire and combustion!
2.2 During dismantling/reassembly
Mark all current settings for the wheelchair (seat, armrests, backrest etc.), and the cable connecting
plugs associated, before any removals. This makes reassembly easier.
Caution:
• Prop up the wheelchair with appropriate supports before starting the disassembly or assembly.
• Never use standard nuts instead of self-locking nuts. .
Note:
• All plugs are fitted with mechanical latches which prevent release of the connecting plugs during
operation.
•
To release the connecting plugs the latches must be pressed in.
• When reassembling ensure that the latches are correctly engaged.
2.3 Before operation / after completion of work:
Caution:
•
Check all fixings for tight fit.
• Only operate wheelchair with correct tyre pressure.
• Check electrical components for correct functioning, incorrect polarity of cables can result in
damage to the electronics.
• As a last check, always carry out a trial run.
5