Moving The Carriage; Installing The Cutter - Kodak 4000 series Quick Start Manual

Kodak Professional large format 4000 series printers
To load sheet media:
Setup/Paper Options/Supply Type/Sheet. Press OK.
1
P ress
2 Load the sheet from the back of the printer, aligning it with the
alignment mark on the platen.
3 Make sure that the media is flat and under the rollers. After a few
seconds, the printer will automatically sense the media's presence
and load it until it reaches the start position on the platen.

Moving the carriage

With the power turned on, select Utility/Access Cartridges on the control panel
to move the carriage away from the service station so that you can install,
change, adjust or clean the ink cartridges, change the cutter, or clean the service
station.
Warning: Do not move the carriage manually as you could damage the printer.

Installing the cutter

A cutter located in the ink cartridge carriage cuts roll media. The printer is
shipped with the cutter installed.
CAUTION: Be careful when handling the cutter to avoid injury. Cutting media
with a worn cutter can cause the media to jam and create a ragged cut line.
Replace the cutter to avoid this condition. Do not cut media on the printer
with an external knife, as you could seriously damage the platen and void the
warranty.
To install the cutter:
Press Utility/Access Cartridge button to move the carriage out
1
from the service station.
2 The cutter fits in the printer on the left side of the carriage. To
remove an older cutter, push the cutter lever down and pull it out.
Install the new cutter by pushing it into the slot until it clicks into
place.
14