Kodak 4000 series Quick Start Manual page 19

5 Remove the cartridge from the carriage and remove the blue tape
from the jet area of the cartridge. CAUTION! Do not tilt the
cartridge up higher than a 30 degree angle. This could cause
the cartridge to lose pressure.
6 Rotate the cartridge one complete revolution counterclockwise to
ensure that there are no twists in the ink delivery line.
7 Check for ink on the jet plate.
Note: Continuous bleeding of the jet plate indicates a loss of
vacuum in the cartridge or an air leak in the lines. A small amount of
ink can be cleaned off the jet plate by dabbing with a moist, lint-free
cloth.
8 Insert the cartridge into the carriage.
9 Repeat Steps 1-8 for each cartridge.
10 Press Utility/Access Cartridges to return the carriage to the
service station.
11 Print the color test, prime test pattern and paper axis test as
described on pages 20-21 and 26.
12 If all colors look correct, go on to step 15. If any color drops out,
prime cartridges as necessary, using the cartridge primer. Place the
suction end of the cartridge primer over the jet area of the cartridge.
Kodak Professional large format 4000 series printers
19