Assembling The Printer - Kodak 4000 series Quick Start Manual

Kodak Professional large format 4000 series printers

Assembling the printer

1 Locate the box containing the printer head and turn it upside down.
Open the box and remove the accessory box which contains the
screws and screwdriver to use for the next steps.
2 Open the box containing the stand and remove the stand and feet .
3 Note that each foot has two casters, only one of which locks. Attach
the feet to the stand legs using the screwdriver and screws provided
in the setup box. Install the casters so that they are diagonally
opposite each other. Lock the casters to prevent the stand from
rolling during assembly.
4 One of the stand legs has a connector on it. Pull the connector from
the access hole in the leg and remove the tie wrap holding the
connector in place. Attach the connector to the receptacle on the
bottom of the print head. Intall the stand legs so that the roll holder
brackets are facing the center of the printer head and align with the
holes in the bottom of the printer head. Attach both stand legs to the
printer head using the screwdriver and eight screws contained in the
setup box.
WARNING: Be careful not to pinch the cable when attaching the leg.
CAUTION: Two people are required to lift the printer.
5 Remove the assembled printer and stand from the box. Save the
boxes and packing materials in case you need to ship the printer.
4