Kodak 4000 series Quick Start Manual page 13

Since media cores can be shorter than the width of the media,
position the media guide 1/8" from the end of the core and lock it
into place.
Press Feed Media/Forward to advance enough media to allow its
4
leading edge to come to the center of the takeup roll.
Using at least three pieces of tape, attach the leading edge of the
media to the takeup roll at the left, right, and center of the core.
As printing progresses, the media is looped down in front of the
takeup core until it is detected by the sensor on the printer leg.
The takeup roll is then activated to roll the media.
Be sure not to block the sensor.
Note: If you are using narrow media and running a long plot, depending on
ambient temperature and humidity, you may want to set a dry time and/or turn
on the dryer as described in the Reference Guide. Because of the print speed
and the narrow media, the ink may not have sufficient time to dry before the
media is rolled onto the takeup core.
To unload the takeup roll:
1 Press the Cut button to cut the media.
2 Roll the printed or unused media onto the takeup.
3 Slide the media and core out of the printer.
4 Release the adjustable roll guide.
Kodak Professional large format 4000 series printers
13