Table of Contents
Advertisement
NAMING A MULTI
You may wish to name the multi file to something more suitable. Simply press the NAME
key and enter a name of up to 12 characters from the front panel keys. You will receive
the usual naming prompts:
Pressing the NAME key again switches the numeric keypad from letters to numbers and
you will receive this prompt:
You may press NAME again to access the numeric keypad's letters. When in the
'numbers' mode, the +/< and -/> keys input '+' and "-' to a name. Pressing NAME again
reverts you to entering letters from the numeric keypad.
Alternatively, in conjunction with the CURSOR keys which can be used to move the cursor
around within the name, you can use the DATA control to scroll through characters.
Once you have completed the name, press ENT/PLAY to finish the naming process.
NOTE: Because only one MULTI can exist in memory at any one time, you cannot copy
the multi file, only rename it. As such, the COPY REN EXIT prompt we have seen
elsewhere is not shown.
SAVING A MULTI
You may save a multi to disk and this will save the multi and all its associated programs
very simply in the SAVE mode. You may then load this multi (and its associated
programs) with one simple operation in the LOAD mode. Please see SAVE and LOAD for
details on this.
LOADING A MULTI
To load a MULTI, press LOAD and select MULTI+PROGS+SAMPS as the type of load.
Now move the cursor to the multi-file stored on the floppy disk/hard disk volume and press
F8 and/or F7. This will load the selected multi and any programs associated with it plus
the samples used in those programs.
S3000XL Operator's Manual
MULTI MODE
Page 43
Advertisement
Table of Contents
